Holiday 2015 Promo15% off all artwork, limited time offer!

Blog Subscription

Enter your email in the box below to receive the latest updates from my blog directly to your inbox.


Newsletter Subscription

Subscribe to my newsletter to receive 4 to 5 emails per year where I highlight important news, available originals, and seasonal specials.

Blog archives: October 2014

How to Mount Canvas on Board

I used to mount canvas on board with Frank's PH Fabric Adhesive. I demonstrated how to do it on a previous blog post: Canvas and the Icarus Board: Final PostAlthough this method worked pretty well, the glue would always moisten the canvas which would take a long time to dry before I could varnish it. I finally found a double-stick adhesive that is suitable for rough surfaces like canvas.


Above are my finished canvas and a roll of adhesive on top of a 24" x 48" Claybord.


Gudy 831 is a very aggressive double-stick adhesive especially suitable for application on rough or textured surfaces. It's acid free (pH 7), passed the photo activity test (PAT), and will not dry out or discolor with age. It's available on rolls with a single release liner. Easily applied by hand, it will never dry out or discolor with age. Gudy 831 can be purchased online from Talas in different size rolls.


After carefully unrolling the adhesive onto the surface of the Claybord (sticky side toward the board), I burnished it with a brayer and trimmed the excess around the edges. I punctured the air bubbles with an X-Acto knife and burnished until the air was all gone. 


Here's a close-up of a seam where I had to join two separate sheets of adhesive because the roll wasn't wide enough. Again, I pressed the seam with a burnisher.


This is the canvas ready to be mounted, after I trimmed the white edges. At this point my piece measures 24.5" x 48.5", half an inch larger than the board, to account for possible misalignment during mounting. 


I created a fold on the release liner to expose a 1" wide section of the tacky area.


I positioned the canvas over the board and, when perfectly centered, I pressed down on the canvas over the exposed 1" section of adhesive.


Then I slowly pulled away the release paper while unrolling the canvas over the adhesive. With a sheet of tracing paper covering the canvas, I gently rubbed the surface with a rag until all the release paper was pulled out.


I rolled a rubber brayer all over the surface protected by tracing paper.


I turned the board upside down and trimmed the extra canvas with an X-Acto knife.


To achieve perfect cuts I used a fresh blade for each side of the artwork.


Finally I placed the board under heavy books overnight. Using Gudy 831 allowed me to begin varnishing the day after mounting the canvas.


Title: "Everlasting"
Size: 24" x 48"
Medium: Prismacolor and Caran d'Ache Luminance Colored Pencils, Neocolor Wax Pastels, Holbein Oil Pastels
Surface: Extra Fine Texture Canvas primed with two coats of clear Art Spectrum Colourfix Primer
Icarus Technique